SCSI support

Ben Pfaff pfaffben@msu.edu
14 Aug 2000 11:54:59 -0400


Mark Szidik - MLC <szidikm@mlc.lib.mi.us> writes:

> I am running RH 6.1 at home.  I recently added a AHA 1520B scsi
> controller.  How do I get Linux to see this controller now?

>From the driver source:

 CONFIGURATION ARGUMENTS:

 IOPORT        base io address                           (0x340/0x140)
 IRQ           interrupt level                           (9-12; default 11)
 SCSI_ID       scsi id of controller                     (0-7; default 7)
 RECONNECT     allow targets to disconnect from the bus  (0/1; default 1 [on])
 PARITY        enable parity checking                    (0/1; default 1 [on])
 SYNCHRONOUS   enable synchronous transfers              (0/1; default 0 [off])
 (NOT WORKING YET)
 DELAY:        bus reset delay                           (default 100)
 EXT_TRANS:    enable extended translation               (0/1: default 0 [off])

 LILO COMMAND LINE OPTIONS:

 aha152x=<IOPORT>[,<IRQ>[,<SCSI-ID>[,<RECONNECT>[,<PARITY>[,<SYNCHRONOUS>[,<DELAY> [,<EXT_TRANS]]]]]]]

 SYMBOLS FOR MODULE CONFIGURATION:

 aha152x=IOPORT,IRQ,SCSI_ID,RECONNECT,PARITY,SYNCHRONOUS,DELAY,EXT_TRANS
 configuration override of first controller

Usually you'll only need to specify the first two arguments (the
port address and IRQ), like this: "aha152x=0x140,11", etc.  You
set the IRQ and port address using jumpers on the card, typically.

> The 1520 is an ISA card anybody able to recommend a low-cost
> low-end PCI controller that is Linux compatible?  I want to spent about
> $40.  I dont need a high-end card because I am not putting HD's on it -
> just scanner, CD-ROM and CD-RW. 

I would just go down to Digilink or CompUSA and pick out a cheap
card that used a supported chipset--e.g., sym53c8xx or aic7xxx or
BusLogic, to name a few.  A printout of `ls' output for the
kernel's drivers/scsi directory might be helpful for this.
-- 
"The BOFH persists despite the resistance and criticism from those
 other people, and takes the road less traveled by.  The BOFH does
 not follow the crowd merely to gain the crowd's approval.  Even if
 the crowd is made of BOFHs." --Greg Andrews