[GLLUG] Command Line Console

Sean picasso@madflower.com
Mon, 15 Jul 2002 15:45:46 -0400 (EDT)


you also might want to look at Kermit. 
Kermit is straight command line. 


On Mon, 15 Jul 2002, Melson, Paul wrote:

> Only if it has been configured to use Telnet for incoming connections.  If you have the appropriate cables, you can use minicom (9600,N,8,1,HWFC) to connect to the console port of pretty much any Cisco device.  I've used it with everything from 1600 routers to PIX firewalls to VPN Concentrators.  Minicom works as good as anything.
>  
>  
> 
> 	-----Original Message----- 
> 	From: Brad Fears [mailto:brad@mtsdev.com] 
> 	Sent: Sat 7/15/2000 4:21 PM 
> 	To: Darrel Clute 
> 	Cc: GLLUG 
> 	Subject: Re: [GLLUG] Command Line Console
> 	
> 	
> 
> 	Can't you just telnet into the device?
> 	
> 	telnet <address>
> 	
> 	On Mon, 2002-07-15 at 11:39, Darrel Clute wrote:
> 	> Hello,
> 	>
> 	> Could any one tell me how to console into a Cisco (or similar) device from
> 	> the Linux command line?  I would prefer this to using a program similar to
> 	> KPPP just because of the stability of the command line.
> 	>
> 	> TIA
> 	> Darrel Clute, CCNA/CCDA
> 	>
> 	> _______________________________________________
> 	> linux-user mailing list
> 	> linux-user@egr.msu.edu
> 	> http://www.egr.msu.edu/mailman/listinfo/linux-user
> 	>
> 	
> 	
> 	_______________________________________________
> 	linux-user mailing list
> 	linux-user@egr.msu.edu
> 	http://www.egr.msu.edu/mailman/listinfo/linux-user
> 	
> 
>