[GLLUG] Disk drive controller question
Stanley C. Mortel
mortel at cyber-nos.com
Fri Feb 6 14:35:13 EST 2009
OK, here's the deal. I'm using Acronis to copy a partition from one IDE
drive to another identical drive, both are 120 GB with a single
partition. One drive is connected to the on-board IDE controller, the
other is connected to a 3WARE RAID controller with only one drive on
it. Each drive is alone on its channel / cable, set to cable select, on
the right connector, etc. If I copy from the IDE to the 3WARE, it takes
about 5 minutes. If I try it the other way around, it tells me it is
going to take 2 hours. There is nothing in my knowledge base to explain
this. Anyone know why this would happen? If you don't know for sure,
any reasonable ideas?
Stan
More information about the linux-user
mailing list