[GLLUG] [Bulk] Antec Drive Unmounting
Marr
wm33 at att.net
Fri Jun 17 23:53:58 EDT 2011
On Friday 17 June 2011 23:29:32 Chick Tower wrote:
> The rails are different than in
> your photo; it looks like they have a thick wire or small rod that is
> curved outward in it's middle that runs along the side of the drive
> (like a parenthesis) and flexes enough to allow them to snap into a
> (supposed) receiving groove inside the drive cage.
That part sounded strangely familiar, but I'll be dogged if I could remember
from what. None of my current cases have such a setup. But I clearly recall
using something like that (not the locking bar, but the snap-in rail with the
curved rod), so I was motivated to do some searching based on that model
number and I found this page:
http://tech.ebabble.net/antec-slk2600amb
There are 2 good photos of the interior, pre-install and post-install. If you
load up the 2 photos in adjacent browser tabs and switch between them, it's
obvious that the top-most (of 4) of the purple locking levers has been slid
aft during the component installation. Given that the guy seems to have only 1
5.25-inch external drive and it's in that top slot, I'd have to assume that
"AFT" = "LOCKED". So if you slide the purple locking lever _forward_, I'd
assume that the drive must somehow be capable of (forcible?) removal.
Bill
More information about the linux-user
mailing list